Independent home-network planning tools
GUIDE / TOPOLOGY

Home network topology and device roles

Map the Internet handoff, router, switch, APs and NAS before selecting hardware.

Draw the logical path first

The baseline is Internet handoff (ONT/modem) → router/firewall → switch → APs, NAS and wired devices. If the ISP gateway also routes, use bridge mode or AP mode where supported to avoid accidental double NAT.

Device roles

DeviceRoleCheck before buying
Router/firewallNAT, DHCP, DNS forwarding, firewall, VPNWAN throughput, sessions, VLAN and VPN support
SwitchWired ports, VLANs and PoEPorts plus 25% spare, uplinks, PoE budget
Wireless APWi-Fi access and roamingWired backhaul, placement and PoE type
NASFiles, backups and mediaWired link, DHCP reservation and UPS

Practical cabling rules

  1. Wire stationary devices whenever practical.
  2. Prefer wired backhaul for multiple APs over wireless mesh backhaul.
  3. Consider 2.5/10GbE uplinks when several 1Gbps flows converge.
  4. Label both ends and record switch ports and cable-test results.

Put these on the diagram

  • Internet handoff and wiring cabinet
  • Device, port number and cable destination
  • PoE device and maximum draw
  • Equipment backed by the UPS
  • Spare ports for future APs, cameras and NAS

Field case

Assume an apartment cabinet contains the ISP ONT and router while living-room Wi-Fi is weak. Before buying a repeater, verify the ONT → router → switch → wired living-room AP path and an independent eight-conductor cable run.

Step-by-step verification

1. Record whether the router WAN address is private. 2. Test the cabinet-to-room cable. 3. Connect a wired AP and repeat three measurements with the same client and position.

Interpretation

A stable gigabit wired link and repeatable room measurements support the design. A private WAN or 100 Mbps negotiation points first to double NAT or cabling.

Applicability limits

Bridge support, apartment cabling, heat and power differ by site. Follow building and electrical requirements.

CCTV + NAS storage calculator →

Completion criteria

  • Decisions and assumptions are written down.
  • Capacity, security and rollback checks are complete.
  • The design was tested against actual device, ISP and local requirements.

Open related worksheet/tool