Independent home-network planning tools
GUIDE / IP · DHCP · DNS

Private IP, DHCP reservation and DNS

Create an address plan that keeps devices reachable without conflicts.

Start with one simple subnet

A small home can begin with a subnet such as 192.168.10.0/24. It normally provides 254 host addresses; .0 identifies the network and .255 is broadcast.

Example rangePurpose
192.168.10.1Default gateway
.2–.49Reservations for switches, APs and NAS
.50–.199DHCP clients
.200–.239Lab or temporary static devices

Prefer DHCP reservations

Reserve the MAC address of a NAS or AP on the router so addressing stays in one source of truth. If a device needs a static address, keep it outside the pool and record its gateway, mask and DNS settings.

Separate DNS failure from Internet failure

  1. Test the local gateway.
  2. Test an external IP such as 1.1.1.1.
  3. If IP works but names fail, inspect DNS configuration and server health.
Address register Record device name, MAC, reservation, VLAN, location, management URL and change date. Do not store passwords in this sheet.

Avoid overlap

Two sites using the same common subnet can conflict across a VPN or double-NAT link. If remote access matters, avoid the most common factory-default subnet.

Field case

Assume a NAS backup fails after the NAS receives a different address. Prefer a router DHCP reservation to an arbitrary static address on the NAS, and verify that the reservation does not overlap another lease.

Step-by-step verification

1. Record IP, mask, gateway and DNS. 2. Inspect leases for duplicate IP or MAC entries. 3. Renew after reserving, then test gateway, external IP and a domain name in order.

Interpretation

Gateway and external IP success with name failure points to DNS. A 169.254 address points to DHCP; duplicate use points to an address conflict.

Applicability limits

The sample 192.168.10.0/24 is not mandatory. Include VPN peers, ISP equipment, IPv6 and firewall policy.

Completion criteria

  • Decisions and assumptions are written down.
  • Capacity, security and rollback checks are complete.
  • The design was tested against actual device, ISP and local requirements.

Open related worksheet/tool